Yonex Stringing Method

Share:

Racket's stringing tension must be strung within the racket specified range. Yonex recommends that crosses be strung at a tension 10% higher than the mains. However, it is recommended that the final 5 crosses be strung at the same tension as the mains as this method will helps the racquet maintain its original shape after stringing.

Racket Frame Type 1

For rackets with 76 grommet holes. Racket models include AX88S, AX88D, AX77, AX66, DUO-ZS, DUO8XP, VT-FB, VT-GZ, VTZF2, VTIF, VT-F, NR-ZSP, NR-GZ, NR-ISP, NR-SP, ARC-FB

MAIN: Start from top centre, keep on stringing until B9 (skip A7, A9 & A11).
Go through B12, directly to A16, and then straight to A14, down to B10 and tie off at B8.
(Opposite side: the same procedure)

CROSS: Make a knot at B6 and start crosses from B9.
Keep on stringing until A7 (skip A12 & A10), then directly to A5 and tie off.

Racket Frame Type 2

For rackets with 76 grommet holes. Racket models include AX9, AX7, AX6, AX2, DUO10, DUO9, DUO7, DUO6, DUO88, DUO77, DUO55, DUO33, VT80ETN*, VT70ETN, VT50ETN, VT8ETN, VT7NEO, NR900, NR800, NR750, NR700FX, NR300NEO, NR95DX, NR70DX, NR10F, NR9, ARC11, ARC6FL

MAIN: Start from top centre, keep on stringing until B9 (skip A8 & A10).
Go through B12, directly to A15, and then straight to A13, down to B10 and tie off at B8.
(Opposite side: the same procedure)

CROSS: Make a knot at B6* and start crosses from B9.
Keep on stringing until A8 (skip A11 & A9), then directly to A5 and tie off.
*Make a knot at B4 for VT80ETN

Racket Frame Type 3

For rackets with 72 grommet holes.

MAIN: Start from top centre, keep on stringing until B9.
Go through B12, directly to A11, and then straight to A10, down to B10 and tie off at B8.
(Opposite side: the same procedure)

CROSS: Make a knot at B6 and start crosses from B9.
Keep on stringing until A7, skip A6 and tie off at A5.

Share: